What's a "Smart Pixel LED Light"

Digital RGB LED Smart Pixel Light are used on advertising signs, iron characters, punched characters, luminous characters, etc. for nighttime lighting embellishment. Usually, the full-color exposed lights are arranged according to different dot patterns, so that they can be changed into colorful characters, animations, patterns and other dynamic effects according to different installation combinations. It is mainly used for the lighting of the city, the outline of the scenic buildings, the sidewalks of the roads and bridges, the outlines of the buildings, entertainment venues, KTV, nightclubs and other night decorations.

installation

1. Insert the lamp. The customer inserts the light from the input port P1 in the order of the wiring diagram according to the wiring diagram provided by us.

You can't use the tool to insert the lamp, it is easy to damage the IC, and you should also take it lightly when you move it, otherwise it will damage the lamp bead.

Note: P1 is connected to the first lamp on the input. If there is P2, P3... then P2, P3... is the first lamp at the input of the other two channels. (P1: P stands for controller port, number is controller port code)

2. Wiring, connect the power supply to the light string with a wire diameter of 2.5 square or more. The positive and negative poles at both ends of the string must be connected to the power line to ensure uniform brightness of the string. (Note that the positive and negative poles should not be reversed.) The wire ends should be welded firmly. Wrap the wire ends with insulated electrical tape to prevent short circuit and leakage.

3, connected to the power supply, our company's full-color string voltage is 5 volts, the power supply with load is 80% of the rated load, analogous to the 300 watt 5 volt power supply with 240 watts of load can be. Guarantee the life of the power supply (0.3W per lamp). The three sets of output lines of the power supply should be connected to the string power line (evenly, the shorter the line, the better). The positive and negative poles can't be reversed. Before powering on, you must check or use a multimeter to prevent short circuit.

4, the controller, the male and female plugs off, from the controller to take out three signal lines (preferably with a 3 * 0.5 three core wire) to the first lamp, the controller GND, DAT, CLK respectively Go to the input of the first light. The length of the ordinary signal line is up to 3-5 meters.